概要 |
Model 8010は, 広い動作範囲を持つ原子力分野/非原子力分野汎用パルスジェネレータです。TTLレベルとECLレベルを同時に持たせるなど,
2つの出力に波形柔軟性を実現しました。1Hz~50MHzの内部クロックレート, 外部トリガー,
シングルサイクル, 同期/非同期ゲーティングにより, 広い範囲のパルストレイン制御が可能です。 Model 8010は, 原子力分野だけでなく非原子力分野でも便利な規格であるAEC NIMモジュールにパッケージされています。モジュールのサイズが小さいため(前面パネル 2.7" x 8.7"), システム内で複数のパルサーを単独で使用したり, 相互接続を容易にすることできます。 |
応用例 | |
周波数源または発振器 Frequency Source or Oscillator |
シングルサイクルパルサー Single Cycle Pulser |
トリガーパルス源 Triggerable Pulse Source |
ゲート発振器 Gateable Oscillator |
ゲートジェネレーターまたはパルスジェネレーター Gate or Width Generator |
ディレイジェネレーター Delay Generator |
ダブルパルサー Double Pulser |
4出力パルサー Four-Output Pulser |
ページ先頭へ戻る(Return to top page)
NIMモジュール, NIM電源ほか関連製品一覧に戻る
仕様 | |
周波数 Frequency |
A: 1Hz から 50MHz まで8レンジ, 連続調整 B: 外部トリガー, 0Hz から 50MHz C: フロントパネルのプッシュボタンによるシングルサイクル A: 1Hz to 50MHz in 8 ranges, continuously adjustable B: External trigger, 0Hz to 50MHz C: Single cycle by front panel pushbutton |
ディレイ Delay |
9レンジ, 25nsec から 1sec, 連続調整 Less than 25nsec to 1sec in 9 ranges, continuously adjustable. |
幅 Width |
9レンジ, 20nsec から 1sec, 連続調整 Less than 20nsec to 1sec in 9 ranges, continuously adjustable. |
ポジティブ出力 Positive Output |
A: スイッチにより, Normal または Complement を選択 B: 振幅: 500mV から 5V まで連続調整, 50オーム(TTL logic) C: 立ち上がりおよび立ち下がり時間 5nsec 未満 A: Normal or complement; switch selectable B: Amplitude: 500mV to 5V continuously adjustable into 50 Ohms (TTL logic) C: Rise and fall time less than 5nsec |
ネガティブ出力 Negative Output |
A: 振幅: 固定 -0.8V パルス(NIM ogic) 50オーム, または -0.5V ベースラインオフセット 50オーム(ECL logic) の -1.5V; スイッチで選択 B: 立ち上がりおよび立ち下がり時間 3.5nsec 未満 A: Amplitude: fixed -0.8V pulse (NIM logic) into 50 Ohms, or -1.5 V with base line offset of -0.5V into 50 Ohms (ECL logic); switch selectable B: Rise and fall times less than 3.5nsec |
デューティー Duty Factor |
各出力において 50%超, complementary pulse mode においてデューティが90%を超える場合があります Greater than 50% each output, in complementary pulse mode duty factors larger than 90% may be attained |
トリガー出力 Trigger Out |
Positive +1.1V 方形波, 50オーム Positive +1.1V square wave into 50 Ohms |
外部トリガー External Trigger |
立ち上がり 3V/usec より大きな Positive I V が必要 Requires positive l V, with rate of rise greater than 3V/usec |
波形ひずみ Waveform Distortion |
全振幅において 5%未満 Less than 5% at full amplitude. |
外部ゲート External Gate |
同期または非同期をスイッチで選択, positive 1.5V信号が必要 Synchronous or asynchronous; switch selectable. Requires a positive 1.5 V signal |
シングル/ダブルパルス Single/Double Pulse |
スイッチによる選択, 最小ダブルパルス spaceing 20nsec, パルスseparationはディレイコントロールにより設定 Switch selectable, minimum double pulse spacing of 20nsec. Pulse separation set by delay controls |
ジッター Jitter |
繰り返しレート, ディレイまたは幅, 0.1% +50psec Repetition rate, delay or witdh, 0.1% +50psec |
寸法 Mechanical |
NIM2幅(span)モジュール, 幅2.7" x高さ8.7", TID-20893 (Rev. 3) Double witdh AEC module, 2.7" wide x 8.7" high in accordance with TID-20893 (Rev. 3) |
質量 Weight |
約1.6kg (3.5ポンド) 3 1/2 lbs., net; 7 lbs., shipping. |
電力 Power Requirements |
A: +12V @380mA, -12V @100mA または B: +12V @80mA, -12V @100 mA, +6V @300mA, 内部にて選択, 側面パネルを外しスライドスイッチをどちらかの位置にすることで設定可能 A: +12V @380 mA, -12V @100mA, or B: +12V @80 mA, -12V @100mA, +6V @300mA, selectable internally. Easily changed by removing side and throwing slide switch into either position |
※ 仕様・納期・価格等については弊社までお気軽にお問い合わせください。
※ また, このHPに紹介されている製品以外で, 取り扱い可能な製品もございます。
詳細は弊社までお問い合わせください。